modem/router to router

[pcfreak49]

Hello, I have a problem, I have a modem/router IP 192.168.0.1 that is connected to a Cisco router 10.10.10.1, we cannot get internet on it.

[Joseph W. Doherty]

As both noted IPs are private IPs, and not valid for Internet, need more details.

[pcfreak49]

yes, I know that they are both private IP addresses, the modem/router has a private IP address rank 192.168.0.1 and public IP rank

the Cisco has a private IP address rank 10.10.10.10.1 that is connected to the modem/router

[M02@rt37]

Hello

Do you perform NAT on your Cisco Router ? Cisco router's interface facing the Modem is in DHCP add ? You need to NAT all the traffic (overload) with the IP add of that interface.

[pcfreak49]

Yes ip nat inside source list ACLG_IPV4 interface GigabitEthernet0 overload

[M02@rt37]

OK @pcfreak49 

What about routing? You have your static route towards modem interface?

ip nat inside and ip nat outside commands are configured on the good interfaces ?

Do ping on your router:

#ping 8.8.8.8 source <LAN interface 10.10.10.x>

#sh ip nat translation

Do you have nat table filled?

[Richard Burts]

It would be very helpful to see the current running config disguising any sensitive information (Public IP, passwords, etc).