cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
356
Views
0
Helpful
3
Replies

MPLS Failover

Peter K
Level 1
Level 1

Hello,

I have an requirement. My HUB location has dual MPLS links from two different service providers. Spoke locations also has dual links from same
service Providers. My requirement is to enable auto fail over between HUB and SPOKE. Currently using Static routing at both ends.

 

Both links must be in active active to handle traffic (assuming any one link fails in spoke, it should access HUB through the other link.

Which protocol can be used at HUB and Spoke.

1 Accepted Solution

Accepted Solutions

Hi Peter. You can run BGP between PE to CE in you hub and spoke and run any IGP proocol like EIGRP, OSPF between CE to your L3.

View solution in original post

3 Replies 3

Peter K
Level 1
Level 1

can someone help?

Hi Peter. You can run BGP between PE to CE in you hub and spoke and run any IGP proocol like EIGRP, OSPF between CE to your L3.

Thanks.can you provide the BGP configuration at HUB end.

Review Cisco Networking for a $25 gift card