12-02-2014 08:21 AM - edited 03-05-2019 12:16 AM
We're seeing an anomaly on our inbound network traffic being slower than our outbound traffic; It's about 20-50 times slower and fluctuates dramatically. Internal traffic is fine and we get full line speed. We're running two 7206VXR routers with NPE-G2 each running a BGP connection to two different providers each receiving full tables. To try to isolate the problem we've pulled the advertisement from one upstream and have statically routed any of our traffic to the download source as to avoid the use of BGP. Removing these complexities the problem still exists. Any help would be appreciated. We've tested this from many sources but in the config examples I'm posting the source IP for test file transfers is 74.86.116.210. This config on either router produces the same results even though they are with different providers. Here are the relevant config segments (counters cleared shortly before grabbing the config):
Cisco IOS Software, 7200 Software (C7200P-ADVENTERPRISEK9-M), Version 12.4(4)XD4, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Mon 23-Oct-06 16:54 by kesnyder
Cisco 7206VXR (NPE-G2) processor (revision A) with 1966080K/65536K bytes of memory.
Processor board ID 33319489
MPC7448 CPU at 1666Mhz, Implementation 0, Rev 2.2
6 slot VXR midplane, Version 2.9
Last reset from power-on
PCI bus mb1 (Slots 1, 3 and 5) has a capacity of 600 bandwidth points.
Current configuration on bus mb1 has a total of 200 bandwidth points.
This configuration is within the PCI bus capacity and is supported.
PCI bus mb2 (Slots 2, 4 and 6) has a capacity of 600 bandwidth points.
Current configuration on bus mb2 has a total of 0 bandwidth points.
This configuration is within the PCI bus capacity and is supported.
ip cef
interface GigabitEthernet0/1
description CONNECTION TO DISTRIBUTION SWITCH
no ip address
load-interval 30
duplex auto
speed auto
media-type rj45
no negotiation auto
interface GigabitEthernet0/1.47
encapsulation dot1Q 47
ip address XXX.XXX.XXX.XXX 255.255.255.0 secondary
ip tcp adjust-mss 1436
standby 50 ip XXX.XXX.XXX.1
standby 50 priority 160
standby 50 preempt
interface GigabitEthernet0/2
description CONNECTION TO INTERNET UPSTREAM
ip address YYY.YYY.YYY.YYY 255.255.255.252
ip tcp adjust-mss 1436
load-interval 30
duplex full
speed 1000
media-type sfp
no negotiation auto
ip route 74.86.116.210 255.255.255.255 YYY.YYY.YYY.ZZZ
scheduler allocate 3000 1000
GigabitEthernet0/1 is up, line protocol is up
Hardware is MV64460 Internal MAC, address is 0014.1c30.af1b (bia 0014.1c30.af1b)
Description: CONNECTION TO DISTRIBUTION SWITCH
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 24/255, rxload 131/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, media type is RJ45
output flow-control is XON, input flow-control is XON
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:00:06
Input queue: 0/75/9/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 516542000 bits/sec, 74589 packets/sec
30 second output rate 96853000 bits/sec, 32405 packets/sec
532103 packets input, 465207530 bytes, 0 no buffer
Received 84 broadcasts, 0 runts, 0 giants, 0 throttles
8 input errors, 0 CRC, 0 frame, 0 overrun, 8 ignored
0 watchdog, 48 multicast, 0 pause input
0 input packets with dribble condition detected
215449 packets output, 71835861 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
GigabitEthernet0/2 is up, line protocol is up
Hardware is MV64460 Internal MAC, address is 0014.1c30.af1a (bia 0014.1c30.af1a)
Description: CONNECTION TO INTERNET UPSTREAM
Internet address is YYY.YYY.YYY.YYY/30
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 66/255, rxload 15/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is force-up, media type is LX
output flow-control is XON, input flow-control is XON
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:01:04
Input queue: 0/75/3/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 62427000 bits/sec, 24819 packets/sec
30 second output rate 260752000 bits/sec, 34769 packets/sec
1597314 packets input, 492958219 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
4 input errors, 0 CRC, 0 frame, 0 overrun, 4 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
2232870 packets output, 2080358220 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
CPU utilization for five seconds: 59%/56%; one minute: 58%; five minutes: 56%
PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process
19 2499185401190427476 209 0.98% 0.66% 0.62% 0 ARP Input
94 374486908 43703755 8568 0.90% 0.86% 0.87% 0 CEF process
73 912363132 66312960 13758 0.73% 0.58% 0.54% 0 IP Input
161 7632 4004 1906 0.24% 0.04% 0.13% 2 SSH Process
41 20239804 5797234 3491 0.16% 0.06% 0.06% 0 Net Background
223 23211012 391925247 59 0.08% 0.07% 0.08% 0 HSRP IPv4
16 14268656 510330634 27 0.08% 0.01% 0.01% 0 EnvMon
238 482988140 183714632 2629 0.08% 0.08% 0.08% 0 BGP Router
226 2025136 873403021 2 0.08% 0.06% 0.08% 0 PPP manager
45 15934272 28739265 554 0.08% 0.09% 0.08% 0 Per-Second Jobs
10 5388 478128 11 0.00% 0.00% 0.00% 0 IPC Dynamic Cach
9 0 2 0 0.00% 0.00% 0.00% 0 ATM VC Auto Crea
11 0 1 0 0.00% 0.00% 0.00% 0 IPC Zone Manager
8 0 2 0 0.00% 0.00% 0.00% 0 ATM AutoVC Perio
15 0 1 0 0.00% 0.00% 0.00% 0 IPC BackPressure
12 43024 28607535 1 0.00% 0.00% 0.00% 0 IPC Periodic Tim
12-03-2014 01:22 PM
Last clearing of "show interface" counters 00:01:04
Well, the output to the command "sh interface G0/2 is totally useless.
4 input errors, 0 CRC, 0 frame, 0 overrun, 4 ignored
However, in 64 seconds you're getting input errors already? That's not good. And look at Gi0/1, within 6 seconds after you've cleared the counters you've got input errors.
I'm suspecting this is speed/duplex mismatch error you're seeing.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide