I’m trying to setup multiple NAT translations within a single router and I currently have a x.x.x.104/29 to play with. This is general list of what I would like to accomplish. Most of the information I can find covers each of these items but not all within the same box. Also I plan on trying to do this as a RoAS setup. To start with I’m using a ISR 2811 and a 3750 L3 Switch. I’ll probably be moving this to my 3945 when I get around to getting a L3 switch and a POE power supply for it.
x.x.x.105/29 this one I want to use just as a PAT
x.x.x.106/29 this one I would like to use for http/https ,ftp, etc. Here all the different services would be offered by different vm’s sitting on my server.
x.x.x.107/29 would be a static translation going to and ASA for VPN traffic.
x.x.x.108-.109/19 I haven’t committed to anything yet. I’m open to ideas of what to use these for. I have a couple Vic3-4fxs/did’s and PVDM’s lying around. Might try to do some voice here.
For the .106/29 would it be ok to deliver all these services on the same vlan or would It be better to break them up. This is simply a best practice question. I may try to do this both ways.
In advance,
Thank you to the whole community.
