cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1949
Views
0
Helpful
31
Replies
Highlighted
Beginner

NAT loopback

Hi.

 

I'm wondering about NAT loopback.

 

My problem is this:

 

I have 1 router Cisco 2911 that is the default gateway of the network. Then I have 1 web server and 1 PC on the internal network.

 

Router: 192.168.10.1

server: 192.168.10.20

PC: 192.168.10.10

 

the routers external IP is 10.0.0.1 /24

I have done the following: ip nat inside source static 192.168.10.20 10.0.0.10

 

I want my PC to be able to reach the web sites on the server through the "external address". Is that possible, to go out through the router and back in again?

 

Kind regards, Tommy

31 REPLIES 31
Highlighted

Hello

Have you tried a different IOS yet?

res

Paul



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future
Highlighted

Hi.

 

I got hold of Version 15.4(2)T1 but I still have the same problem.

The NATed site is accessable on the NATed IP externally but not from the LAN.

 

I attached the config.

 

Kind regards, Tommy