nat outside to outside

[unbkbl]

Hi Cisco community, thanks in advance for reading this post.

I have a small question:

Service                     INTERNET 

Provider                   Access

OUTSIDE                 OUTSIDE

               \                           /

                \                         /

                 \                       /

                  \                     /

 ETH0:192.168.5.1     ETH1: PUBLIC IP

                  OUR ROUTER

                       INSIDE

                   CISCO 1941

I just want to know if it is possible to create a NAT rule that allows the Service Provider segment [192.166.5.0/24] to access the Internet without changing the NAT interface type [from NAT OUTSIDE to NAT INSIDE] there are some other configurations that make difficult for me to make that change, I want hosts [192.168.5.15 and 192.168.15.16] to access the Internet.

Any Ideas?

Thanks in advance

[Vasilii Mikhailovskii]

Hello.

Could you please provide your current configuration for NAT on the router and show ip nat stat/sh ip nat trans?

[Peter Koltl]

http://www.cisco.com/c/en/us/support/docs/ip/network-address-translation-nat/6505-nat-on-stick.html

you can get the clue from this article