NAT problem on ASR920 24Ports

[gtomasicchio]

Hi everyone. Is it possible to do nat on a 24 port cisco asr920?
Thank you

[MHM Cisco World]

NAT is done in L3 interface' so if these port is config with IP then sure you can use it for NAT

MHM

[gtomasicchio]

L2 services, option however supported (but not tested) by the ASR-920-12SZ-IM.

[MHM Cisco World]

If port is L2 you can not use it for NAT.

There is what we called L2 NAT but this only support in IEEE SW serires 

https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/industrial/software/configuration/guide/b_l2_nat_ie.html

MHM

[paul driver]

Hello
Nat doesn't seem to be supported for this model

[MHM Cisco World]

I appreciate if yoh have doc.' Share it here

Thanks alot

MHM

[paul driver]

Hello
check the cfg guides for the ASR920 - here

[Ramblin Tech]

I do not see NAT support listed in either the ASR 920 data sheet or config Guide for any models.