NAT/Route-MAP issue

[Hasrat Bhanot]

Hello,

Would like some help here, I have configured one to one NAT to allow server ip address to use public ip x.x.x.x which is part of block of 5 public ip addresses. Router interface is configured with public ip y.y.y.y, so if I check on the server what is my ip i get x.x.x.x, but after configuring route-maps (need these to do the ISP fail over), i get y.y.y.y as public ip address for server when i check on what is my ip, this is causing issues for emails to bounce back.

Any suggestions to resolve this issue.

Thanks in advance.

[ahmedshoaib]

Hi;

Can you share the route-map? 

As a ISP failover, the ISP need to forward the traffic of your public IP on Secondary link.

Thanks