Hi,
I'm working on a network architecture as presented below :
PC1 -- Router 1 configured as Bridge -- Router 2 -- PC2
My Router 1 need to be configured as a bridge (the bridge is done between gi0/0 and gi0/1 by using a BVI interface).
Router 1 is 3825 with 12.4.15.T10
Router 2 is 2811 with 12.4.15.T10
Between PC1 and PC2, the ping is full OK
My problem :
I must install a NM-NAM Card in the Router 1 (bridged) to capture all traffic through my Router 1.
By studying Cisco site, I can't find my network configuration because I use a Router1 that is used as a bridge.
Is it possible to add my Network Analysis Module in the bridged Router1 and capture all traffic through it ?
Thanks a lot,
Best Regards,
Julien