cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
559
Views
0
Helpful
1
Replies

Network Module for a DS3 Point to Point connection

angel-moon
Level 3
Level 3

Hello everyone,

I want to verify I have the correct module. For a 2851 and a 45Mbps DS3 I have a NM-1A-T3 1-port DS3 ATM Network Module. I have been told that I need a different modeul in each 2851. I am told I need a NM-1T3/E3. The info on the circuit from the ISP is Interface: G.703-BNC-75 ohm

Framing Coding: B3ZS/C-Bit

Can anyone verify what module I need?

Thanks in advance. All replies rated

1 Accepted Solution

Accepted Solutions

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Angel,

an ATM T3 is a different thing then serial DS3.

a NM 1T3/E3 is the right module for a non ATM DS3 connection.

ATM modules may use the same OSI layer1 standard but cannot fallback to behave like simple serial ports (at least in this class of devices)

Hope to help

Giuseppe

View solution in original post

1 Reply 1

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Angel,

an ATM T3 is a different thing then serial DS3.

a NM 1T3/E3 is the right module for a non ATM DS3 connection.

ATM modules may use the same OSI layer1 standard but cannot fallback to behave like simple serial ports (at least in this class of devices)

Hope to help

Giuseppe