no chance to properly debug an ipsec vpn tunnel on RV345

[timo.woellner1]

a vpn scenario like hub-and-spoke
1) central-vpn-hub = palo alto networks firewall
2) branch-offices = RV345

I have several subnets that I would like to route through a VPN tunnel. I have a many-to-many IP subnet configuration. 2 source networks to 7 target networks, i.e. a maximum of 14 SA bundles in phase 2. The behavior is not ok, not all SA bundles are formed. I only see that on the mutual firewall, because I have no way of seeing details of Phase1 and Phase2 on the RV345.
I am very unhappy with it. All IP-Groups are fine !

Does anyone know a trick?
i miss ssh cli loggin......

[Georg Pauwen]

Hello,

not sure what you are looking for exactly...debug your VPN on the RV345 ? All debugging is done through the GUI:

https://www.cisco.com/c/en/us/support/docs/smb/routers/cisco-rv-series-small-business-routers/smb5416-configure-system-log-settings-on-the-rv34x-series-router.html