I faced with strange behavior of Cisco 2901.
I strat ospf process on router, do some ospf manipulations and than turn off ospf with
R1(config)#no router ospf 1
But after that when I start to change my config: shut/no shut interfaces
I see OSPF debug messages
R1(config-fr-dlci)#interface Serial0/0/0.5 point-to-point
Jul 5 12:33:13.004: OSPF EVENT Se0/0/0.5: Route adjust
Jul 5 12:34:15.076: %SYS-5-CONFIG_I: Configured from console by consoleip pro
R1#sh ip protocols
*** IP Routing is NSF aware ***
How it can be? Thereis no OPSF process on R1.
Did you check the licence? I had a similar issue on one 2911 and it was all about the license ... of course the last thing i have checked
hope it helps
from the IOS 15 you do not have anymore the features enabled as per 12.4 or previous IOS lines. when you buy the 2900 series (as others) you now get the IP Base license and then you need to upgrade that license with the features you require:
- unified communications
or a combination of those. In my case, i hadn't upgraded my 2911 and i could not configure BGP on it even if i could see some BGP commands.
Hope it helps
Are you read the question?!
I'm asking about strange behavior of OSPF.
Why OSPF continues to generate debug messages, when I turn OSPF off?
Sent from Cisco Technical Support iPhone App