Packet Tracer - WAN config router to router using Serial DCE?

[amnbhrmistic]

Here's my network scheme in Packet Tracer:

How do I do the routing in CLI to connect those three routers?

Note that the routers are in different cities. Any videos or tutorials I can follow?

Thanks.

[cadet alain]

Hi,

You can use static routing or any IGP like RIPv2,EIGRP or OSPF.

you will find many tutorials on routing on the internet.

Regards.

Alain.

[johnlloyd_13]

Hi,

You can start by using RIP for networks with less than 15 hops.

http://www.trainsignal.com/blog/cisco-how-to-configure-rip-1

Here's a good link for training videos:

http://www.cbtnuggets.com

Sent from Cisco Technical Support iPhone App