Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
511
Views
0
Helpful
1
Replies

Pix failover crashed

Rupesh Kashyap
Level 1
Level 1

‎10-26-2010 02:37 AM - edited ‎03-04-2019 10:15 AM

Hi, I have one pair of PIX which is working as active and standby. Somehow, standby is failed.

Now I got one new Pix from Cisco, please suggest how can I configure standby so that it can be synced with Primary.

Please suggest me same process for ASA too.

Labels:
0 Helpful
1 Reply 1

gatlin007
Level 4
Level 4

‎10-26-2010 10:02 AM

This is a good general link:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

My advice, go to the Cisco documentation site and find the document that applies to your specific hardware/software.  There will be a chapter dedicated to failover.  Follow this guide EXACTLY.  Straying from the steps can lead to unexpected results.

Here's an example for ASA with version 8.1

http://www.cisco.com/en/US/docs/security/asa/asa81/config/guide/failover.html


Chris

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card