07-23-2009 05:27 PM - edited 03-04-2019 05:31 AM
In port mirroring, do I need to configure my probe with ip address?
07-23-2009 07:22 PM
No, You do not need to configure an IP address on your probe. A destination "SPAN" port will receive all traffic from a source "SPAN" interface.
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015c612.shtml#descp
HTH,
Mark
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: