Problem booting Cat 4006 Sup II - Keyboard ineffective

[mahmoodrahman]

This 4006 swtich has Sup II and two L3 router modules (WS-X4232-L3 )

I connected to console and

did clear module on the two L3 modules.

'clear mod 2' and 'clear mod 6'

After booting it shows error message.

So I thought I'd go into ROMMON pressing Ctrl-C and reload IOS.

The problem is the keys on the keyboard has no effect!

I just see display scroll by.

It shows all the modules are online with

green status light on the modules.

I get this strange message every two minutes:

%SYS-4-P2_WARN: 1/Tag 101 on packet from 00:07:0d:98:84:0a

port 6/1, but port's native vlan is 1

I appreciate any help

Thanks.

[Prashanth Krishnappa]

Clear mod is not a valid command. Any reason why you want to go to ROMMON prompt? If you want to go to ROMMON, change the config register to 0x0 using "set boot config-register 0x0" and reset the switch.

Regarding the error message, it is because you have a native VLAN mismatch on port 6/1 on the Supervisor and your Layer 3 blade in slot 6.