cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
600
Views
15
Helpful
4
Replies

Problem of EIGRP

alexcjuz
Level 1
Level 1

HI,

I got a problem with EIGRP as the attached file.

In this file, I suppose the R2 router should be a neighbor with R1 and R3.

But as the file , they don't.

Please help me finding the problem. Thanks.

Alex

2 Accepted Solutions

Accepted Solutions

Martin L
VIP
VIP

it looks like your mixed up interfaces and IPs on R2, pairs are going to wrong routers with current IPs; For a router to establish relationships they must be on the same network/subnet.

 

Regards, ML
**Please Rate All Helpful Responses **

View solution in original post

Hello,

in addition, you also need to announce 'network 10.1.222.0 0.0.0.31' on R2.

Attached the revised, working file.

View solution in original post

4 Replies 4

Martin L
VIP
VIP

it looks like your mixed up interfaces and IPs on R2, pairs are going to wrong routers with current IPs; For a router to establish relationships they must be on the same network/subnet.

 

Regards, ML
**Please Rate All Helpful Responses **

Hello,

in addition, you also need to announce 'network 10.1.222.0 0.0.0.31' on R2.

Attached the revised, working file.

you need to add network to neighbor under EIGRP for all three router. 

alexcjuz
Level 1
Level 1

yes, I mixed up interfaces. The packet tracer's interface labels misleading me. Thank you.

 

Review Cisco Networking for a $25 gift card