cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
43032
Views
31
Helpful
6
Replies

Problem updating from 3.x to 16.x on my 4331. unknown image structure

mhdganji110
Level 1
Level 1

I'm unsuccessful trying to update my 4331 from 3.x to 16.x and facing this error and booting witht he old one.

 

Boot image size = 583079197 (0x22c1151d) bytes

Package header rev 3 structure detected
Calculating SHA-1 hash...done
validate_package: SHA-1 hash:
        calculated 595cdb24:b9751f91:731a4622:7034be2b:f11d9c77
        expected   595cdb24:b9751f91:731a4622:7034be2b:f11d9c77

RSA Signed RELEASE Image Signature Verification Successful.
Package Load Test Latency : 10646 msec

Unknown image structure
boot: error executing "boot bootflash:isr4300-universalk9.16.09.01.SPA.bin"
autoboot: boot failed, restarting...

 

My config is this way:

boot-start-marker
boot system flash bootflash:isr4300-universalk9.16.09.01.SPA.bin
boot system flash bootflash:isr4300-universalk9.03.16.04b.S.155-3.S4b-ext.SPA.bin
boot-end-marker

Any idea?

2 Accepted Solutions

Accepted Solutions

Hello,

 

the syntax looks ok actually. Can you try and upgrade the ROMMON (latest release is isr4200_4300_rommon_169_1r_SPA.pkg) ?

View solution in original post

Although the image was copied and verified but I decided to use a different and a little older image:

isr4300-universalk9.16.06.03.SPA.bin

And it was installed and is working properly

Now I'm going to retry installing the first one and will keep everyone informed

Thanks

 

View solution in original post

6 Replies 6

Hello,

 

the syntax looks ok actually. Can you try and upgrade the ROMMON (latest release is isr4200_4300_rommon_169_1r_SPA.pkg) ?

mesehar
Cisco Employee
Cisco Employee

Yes, upgrade the ROMMON and if that does not help too, try downloading the image again.It could be a copy issue.

Leo Laohoo
Hall of Fame
Hall of Fame
Upgrade the ROMmon first.

Although the image was copied and verified but I decided to use a different and a little older image:

isr4300-universalk9.16.06.03.SPA.bin

And it was installed and is working properly

Now I'm going to retry installing the first one and will keep everyone informed

Thanks

 

Now the newer IOS-XE is also loaded flawlessly.
The first one had updated ROMMON and so ...
I just can't figure out why the new IOS didn't attempt to upgrade the ROMMON (just like the a-little-older-version IOS did)

Thank you   mhdganji110         I had the same problem    going from 3.16.04  (new box from cisco) to 16.6.4

troubleshot it almost the same way

With your suggestion  I loaded 16.3.7 with no problem, and after the reboot loaded 16.6.4      

Review Cisco Networking for a $25 gift card