I am using a cisco 2811 router that has the fa0/0 and 0/1 ports configured for internet. I am trying to config int fa0/2/0 which is an add-on card for network connectivity and when I try to give the port an ip address, this is the message I get: ...
Forum Posts
Please See Diagram: - I have 2 sites (site-1 and site-2) running EIGRP. - Each of these sites is connected to an MPLS service provider to reach remote sites. - Site-1 is currently the exit point to reach remote sites via R5. I would like to make ...
Hi, I have couple of ASR's in my production and most of them are running encryption and throughput license's namely SLASR1-AES and FLSA1-1x-2.5-20G. I want the serial information from the configuration file. or atleast want to know which device is r...
Hi, Need advice on an issue. We have a L3 port-channel (fiber metro ethernet) across two separate providers clouds. ASR to ASR. 1 link is provider A and other link in the port-channel is provider B. When something in the provider's cloud breaks...
Resolved! Solving output drops and input errors
Below is output from the LAN interface on our Cisco 1941 router. This interface connects directly to a port on an HP Procurve switch. Note the output errors, CRC error, and input errors in bold. I have read several posts and articles describing what ...
How do I configure Cisco ASA to communicate with Meraki and vice versa. Our servers are currently connected to Meraki and would like computers connected to ASA to communicate with the servers as well. We are trying to replace Meraki with Cisco ASA ...
Resolved! Error
hI GUYS,I got an error in my 6500 and my MSFC had a switchover .The error is given below from log.What does this error means ? and is this anywhere related to MSFC switchover.ERROR:35. 3/12/2007,10:33:27: titan_intr_hdlr: Main Intr 0x0; Module 0x0,...
Hello All, I am practising a scenario and I got really frustrated. I am wondering if some one can put me in the right direction Its a simple OSPF- BGP route filtering (and I'm stuck!) AND a simple MED config on R4 (Which doesn't work!) Lets sta...
Hi I need to know if these licenses are sent e-delivery or if it paper based because of customs requirements. Thank you Philippe
Resolved! Vlans and OSPF
Hi these is my Topology. PASSWORD : console or telnet I'm able to ping from pc(s) to pc(s), but when I tried to ping for pc 2 to 192.168.101.3 I can't and from Pc4 to 192.168.100.3 I know my problem is between the switches. Can someone please he...
I'm currently running a Cisco router 2951 with the serial interface connected to the ISP with a bandwith of 45Mb. I would like to upgrade the bandwidth to let's say 150 or 200 Mb. My understanding is that T3 can't handle that bandwidth. I also have 3...
So I'm attempting to use the IOS to XE convertor tool, and having difficult time understanding the output results and why some lines are showing "Unprocessed" . I have like 191 lines showing "unprocessed" with pretty basic commands, that don't make s...
Resolved! ASA5516 Port Channel Help
Guys I am stumped with this, and honestly probably doing it wrong. I have an ASA5516 that i am putting at an offsite location to do a point to point VPN. My remote location has given me two ports configured as trunks with VLAN pruning to only allow...
Hello, i have cisco 6500 i need make it pppoe, i have full pppoe server in mikroik i will send you the mikrotik configuration and please change it to cisco and every line write a notice for converted line ( Code ) /interface vlanadd interface=e...
