Problem with Failover

[join_sn09]

Dear All,

Please advices me!!!

Now my system used fail over with ISPA and ISP 2, and use the router 1841 with module hwic-4fe.ISP1 is Primary and ISP2 is Backup.i have the problem: when ISP1 down ( i mean ISP has the problem but on router int F0/1 still up).So my client cannot access Internet. By the way when i take out ISP1 from Router it switch to ISP2.

Please see in the attach file.

Best Regards,

Join

[JORGE RODRIGUEZ]

Thats fine, then leave as

type echo protocol ipIcmpEcho 192.168.168.1

but did you configured the two new nat statements given and try test .

[join_sn09]

dear Jorge,

Router(config)#ip nat inside source route-map NAT-ISP1 interface FastEthernet0/1 overload ?

my router not support command you u gave me.

this is my flash, could you have other command ?

c1841-advsecurityk9-mz.124-2.T1.bin

Best Regards,

Join