Problem with NAT

[GRTO]

Hi Everybody,

im havin a problem with NAT at cisco router  7206VXR (NPE-G1) processor, Software (C7200-ADVENTERPRISEK9_SNA-M), Version 12.4(6)T11

The configuration is as below:

ip nat inside source list 2688 pool Office overload

ACL 2688

10 deny ip 192.168.100.0 0.0.0.255 192.168.0.0 0.0.255.255

20 deny ip 192.168.100.0 0.0.0.255 10.10.120.0 0.0.0.255

30 permit ip 192.168.100.0 0.0.0.255 any

interface GigabitEthernet0/2.88

description gateway Vlan Office

encapsulation dot1Q 88

ip address 192.168.100.129 255.255.255.0

ip nat inside

Im havin problem only with one IP: 192.168.100.42, which it nats while communicating with host 192.168.200.75, but from ACL this communication must not do NAT. in addition, it appears as NAT static, but i have not configure static nat for no one of these IP-s

Thank you in advance

[Marwan ALshawi]

Can you do clear ip nat translation *

then enable debug ip nat detail

And make a new session from that host/ip and post it here

By the way the clear ip nat will rest all active sessions !

Sent from Cisco Technical Support iPhone App

[Jon Marshall]

Marwan

Can i ask a favour. Can you take a look at this thread for me -

https://supportforums.cisco.com/thread/2099823?tstart=30

you are better at these more complex NAT setups than i am and i am bit busy to lab it up.

Thanks

Jon