cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1161
Views
0
Helpful
1
Replies
Highlighted
Beginner

Problems with SVI

Hi:

I have a router 2901 with a EHWIC-D-8ESG-P card.

I configured vlans and DHCP pools but when I connect a PC to a port of the switch, th PC doesn´t adquire an IP addrees of the DHCP pool.

I know I have to configure SVI's in the router with IP addresses as gateways for the vlans. I have done it, but the vlan interface that I configure always appears as down down.

I applied the no shutdown command to the  vlan interface but this continues in the same status.

What do I have to do for resolving this problem???

Please, help me.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

have you configured that vlan in layer 2?

unless there is no active(up) port in that vlan, Vlan will not come up.(and it takes 1 to 2 minute to vlan to comeup once a port is in that particular vlan and something is connected to that port)

View solution in original post

1 REPLY 1
Highlighted
Beginner

have you configured that vlan in layer 2?

unless there is no active(up) port in that vlan, Vlan will not come up.(and it takes 1 to 2 minute to vlan to comeup once a port is in that particular vlan and something is connected to that port)

View solution in original post