Routing

Hi,I'm troubleshooting a connection problem with a CISCO1812/K9. I've narrowed it down to being a PPP CHAP authentication problem.Here is the debug that shows the PPP athentication messages:MYROUTER#debug ppp authentication*Dec 22 20:27:55.198: BR0:1...

Hello,I have one public IP address but multiple local servers that run on the same port. I cannot change the port the clients use to connect to this server, so I can't do a port map in my NAT router. The solution I had in mind, is to filter on source...

I want to purchase CISCO2901-SEC/K9Please let me know all its specification and how many Ethernet ports supported by its modules?Thanks

HiI`m connecting a client directly to a 3750, and giving them a public IP.On the port I have set spanning-tree bpduguard enableBut I guess I shold also set some storm control etc.What settings shuld I use for storm control?The client has a 100Mbps in...

Deploying a network with ASA having 2 Public Ranges and 1 Private Range.The Public range is xx.xx.xx.ab\29& xx.xx.xx.cd\28On ASA interface 0/0 i have assigned IP \29& on the inside interface I have assigned 192.168.209.4\24Now would i be able to use ...

I have rotuer 3825  172.16.11.1 connect with 1811  172.16.11.200. I did sh ip route. here is result.   10.0.1.0/24 [110/2] via 172.16.11.1, 00:27:26, FastEthernet1    10.1.1.0/24 [110/3] via 172.16.11.1, 00:27:26, FastEthernet1    10.2.1.0/24 [110/4]...

How to add a wic-2t card on router 2800 Had the card as follows I want to know routr 2880, such as the following picturePossible help

Hello I have a 1 port channelized T1/E1 and PRI HWIC (data only) (HWIC-1CE1T1-PRI) Card. I want to know how to configure it, It will be a backup line for the ADSL link which is on static PUBLIC IP through which the remote users are connecting through...

Recently had an issue where a routers buffers became full and only a reload fixed the issue. What was strange is that the there was a 100mb circuit between the 2 routers yet only 10meg was being used (CPU was at 100%). Soon as the reload was done it ...

What specific commands are needed to configure qos on a router?Two sites:Cisco 2911  (Site 1)                                              Cisco 2911 (Site 2)Data VlanManagement VlanI want to configure QOS on Site 1 where the Data Vlan traffic is alw...

Hi Friends,I am facing lots of issue with cisco 4507 switch recently.. Every alternate day, its CPU is getting utilized by 99% and network stopped working..finally it has to be restared. please help ...Below is the CPU utilization of the process:- --...

Hi all,I need help to resolve this issue with my Cisco 877W. I configured it for PPPoE. But once I plug in the ADSL line, the dialer interface will get IP Address. But after like 2 minutes the PPP link will go off and I will get this log message: "In...

hi community,I have a really weird issue with my cisco catalyst 3560G. After having researched back and forth, I'm running out of ideas ... maybe someone in here is guru enough to help me out!device: cisco catalyst 3560gios: 12.2-53(SE) IP SERVICESsc...