02-14-2008 11:20 AM - edited 03-03-2019 08:43 PM
Using an 1841 with an Ethernet WAN link and using a VLAN for the WAN circuit. I created an outgoing QoS Policy and assigned this to the VLAN interface. From the CLI, I can show policy-map of the VLAN interface and see packets being matched to the QoS policy, however, I would like to use the SDM to monitor the QoS Status - and it is not displaying the matched packets for the VLAN interface. I assume this is just a "feature" in regards to VLAN's. Can someone educate me? or point me to the correct documentation? or let me know what I may possibly be doing wrong?
Thanks
tj
02-14-2008 03:21 PM
Hi Tim,
In all honesty, gave up with SDM. There is always something that doesn't do, or doesn't do right.
If the value you're interested is pollable with SNMP (not sure now), get a grapher and point it to the right OID to monitor.
02-15-2008 06:57 AM
Historical graphing is the goal, however, most monitoring solutions aren't as granular as the 5 second updating that the SDM provides. In regards to the SDM, it is showing the information on physical interfaces (serial), just not for the VLAN which is why I believe I either have something configured wrong, or it's just inherant with "virtual" interfaces.
Tj
02-15-2008 07:50 AM
Hi, I use and recommend prtg, and can set polling interval as small as 1 second.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide