I am trying to configure a qsig-gf link between an Alcatel PBX and a cisco router with IOS 12.4, but I did not find any document concerning this subject.
here is the show version :
Cisco IOS Software, 3800 Software (C3845-ADVENTERPRISEK9-M), Version 12.4(24)T8, RELEASE SOFTWARE (fc1)
ROM: System Bootstrap, Version 12.4(13r)T10, RELEASE SOFTWARE (fc1)
The link is working in qsig-bc.
The basic command to setup qsig-bc on the router is "isdn switch-type primary-qsig".
How can I configure GF instead of bc?
Are there any commands on Cisco Router specialized for QSIG-GF ?
Does the primary-qsig apply the same qsig gf features or just basic features ?