Reload manual or power off on router

[yavuz.ozdemir]

Dear,

We have router which is up since 2 days and I would like to know if the router has reloaded by CLI (Reload) or by power off(Electrical problem)

ROM: System Bootstrap, Version 12.4(12.2r)T, RELEASE SOFTWARE (fc1)

BOOTLDR: Cisco IOS Software, 7200 Software (C7200P-KBOOT-M), Version 12.4(4)XD9, RELEASE SOFTWARE (fc1)

Router-Test-01 uptime is 2 days, 21 hours, 0 minutes

System returned to ROM by reload at 16:54:56 UTC Mon Feb 9 2009

System restarted at 16:56:23 UTC Mon Feb 9 2009

Last reload reason: Reload Command

Last reset from power-on

1 FastEthernet interface

4 Gigabit Ethernet interfaces

2045K bytes of NVRAM.

[andrew.prince]

it was manuall reloaded from the cli.

[yavuz.ozdemir]

How you can say it?

[kelvin.blair]

This statement indicates it...

Last reload reason: Reload Command.

If it helps, please rate post..

[yavuz.ozdemir]

Thanks, I rate it

[JamesLuther]

Hello,

Because the output says

"System returned to ROM by reload at 16:54:56 UTC Mon Feb 9 2009"

If it was a power problem it would have said something like

"System returned to ROM by unknown reload cause"

Thanks

[Leo Laohoo]

They're all right. The second and the last line always gives you a clue.

If it's a power outage, the line would go something like "System returned to ROM by power-on".

If there was something wrong, in this case a system crash, you'd get an alarm like this:

System returned to ROM by error - Software Forced Crash Exception (0x0700)!, PC 0x3ED134

System restarted at 05:10:29 AEDST Tue Nov 18 2008

If it was reloaded, you still get this

System returned to ROM by reload at 15:55:01 AEDST Fri Feb 6 2009

Does this help?