Removing TFTP from Boot variable

[Gyotaku]

Hi all,

I'm having issues upgrading the firmware on a 1101 rugged router. I transferred the new firmware using

TFTP

from my laptop to the router. However, after using the

boot system flash bootflash:filename

command and reloading, it goes into a boot loop saying:

TFTP boot

command not supported

........

autoboot: boot failed, restarting...

Resetting .......

I'm able to boot to rommon to choose a firmware to boot to and after checking boot variables it shows this: 

BOOT variable = tftp:ir1101-universalk9.17.09.03.SPA.bin 255.255.255.255,12;tftp:ir1101-universalk9.17.09.03.SPA. 255.255.255.255,12;flash:/ir1101-universalk9.17.09.03.SPA.bin,12;bootflash:ir1101-universalk9.17.09.01.SPA.bin,1;
CONFIG_FILE variable does not exist
BOOTLDR variable does not exist
Configuration register is 0x2102

Standby not ready to show bootvar

Why does it keep trying to boot to

tftp?

I tried some commands to remove that first part of the bootvar, but it's still there. 

[Gyotaku · Accepted solution]

Never mind. Issue was resolved. 

When attempting to remove the "tftp" line in the boot variable, I was copy and pasting from 

sh boot

.

tftp:ir1101-universalk9.17.09.03.SPA.bin

 This was incorrect. After I copied and pasted what I saw in 

sh run

, I was able to remove that part of the boot variable. 

[marce1000]

@Gyotaku  - If you rely on the community then it is better to post the solution too , so that we all can learn from you , 

 M.

[Gyotaku]

Sorry about that! I've edited my solution to reflect what I did.