cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
382
Views
0
Helpful
3
Replies

RIPv2 question

The_guroo_2
Level 2
Level 2

Suppose We have a CE router which has Ip address of 1.1.1.1 and PE router has Ip of 1.1.1.2

 

from CE we have to advertise on network the command will be as below

 

router rip

version 2

network 10.0.0.0

no auto summary

 

Do i have to advertise the 1.0.0.0 network ???? keeping in mind that is the WAN addressing

 

never worked on RIP so thanks guys if someone can answer this

3 Replies 3

Akash Agrawal
Cisco Employee
Cisco Employee

 

ofcourse. Network 10.0.0.0 does not cover ip add 1.1.1.x. So you need to advertise 1.0.0.0 network.

so if the WAN interface had 139.5.6.132/30 (subnet)

 

our side 139.5.6.133/30   -------------> remote side 139.5.6.134/30

 

should we add the following config

 

139.5.6.132

or

 

139.5.6.0

Keeping in mind its /30

 

regards

 

Remember that if you use "no auto summary" command you must specify the subnet, for example :

network 139.5.6.132 255.255.255.252

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco