Router for dial up access

[net buzz]

Hi!

I am designing a solution whereby remote users will need to access the central server using analog lines.

I have chosen the Cisco 2811-SEC/K9 router, HWIC-1CE1T1-PRI card and the PVDM2-36DM modem module.

The main site will be equipped with an ISDN PRI line having 30 channels.

The 30 remote users will each be equipped with a modem enabled PC and will be having an analog telephone line.

The remote users will need to dial up using the ISDN line number and the secure the connection using a defined username and password.

Is there any additional hardware required for the setup to work properly.See attached document.

See attached document.

Thanks,

Alvin

[Shelley Bhalla · Accepted solution]

Hi,

As far as Hardware goes this is enough to do what you are doing.I have seen this hardware used for dial-up in the past many times.

Thanks

Shelley Bhalla

CCIE #20002

Cisco TAC - Carrier Services