Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, The Cisco 2911-SEC/K9 router is configured for IPSec VPN but it looks like the maximum number of simultaneous VPN sessions possible is 9.Please advise whether this is related to the default number of sessions on the router which is 9. router#...
Hi! I have configured a WS-C2960L-SM-48TS switch with multiple VLANs which are working fine.Another switch which serves VLANs 10,40,50 has been connected to the 2960L switch on interface Gi0/46.Interface Gi0/46 has been set as Trunk and VLANs 10,40,5...
Dear all, The Cisco ASA firewall has been upgraded from version 8.2 to version 9.12 and the configuration done accordingly.With the new configuration, the services are not working.Thanks to advise on the solution. Scenarios are as follows:Inbound Mai...
Dear Support,
I have configured a Cisco switch for 802.1x Authentication with RADIUS NPS.
The switch ports are configured with DATA VLAN and VOICE VLAN.
Only the PCs should authenticate with the RADIUS server and the IP Phones should bypass 802.1x ...
Hi!
I am getting an issue with a Cisco 6509-E switch as it goes to rommon mode each time it is restarted.
From the rommon mode, the switch can only be booted when using the IOS from the PCMCIA card (disk0).
Following successful booting from disk0, s...
Hi! The other switch is a Netgear.I have configured the uplink port 24 as follows:VLAN 10 - TaggedVLAN 40 - TaggedVLAN 50 - Tagged Please advise whether the above configuration is ok for the uplink from Netgear to Cisco switch
Dear RJI, Are the following NAT statements correct? For Inbound SMTP traffic:nat (dmz,outside) source static Mail-Server-IP Mail-Server-Public-IP service obj-smtp obj-smtp For Inbound HTTPS traffic:nat (inside,outside) source static Web-Server-IP Web...
Hi Leo!
I have executed the commands as mentioned.
However after saving and reloading, the Cisco 6509 goes back to rommon mode.
Please see below output:
rommon 1 > boot disk0:s72033-ipservicesk9_wan-mz.122-18.SXF13.binLoading image, please wait ...
...