Hi,
We want to configure RTR in our network ,having a Cisco 6506 core Switch & 50 Cisco 2960 Switches. As per the ios on the 6506 the rtr command is supported not the ip sla , so we want to configure it on it.
The RTR configuration on the Source device (Cisco 6506 Sw) can be done through the below commands :
1) enable
2) configure terminal
3) rtr <Entry number>
4) type echo protocol ipIcmpEcho <Hostname or A.B.C.D IP address or hostname> source-ipaddr < IP address >
5) frequency seconds
6) exit
7) rtr schedule entry-number [life {forever | seconds}] [start-time {hh:mm[:ss] [month day | day month] | pending | now | afterhh:mm:ss] [ageout seconds] [recurring]
8) exit
RTR configuration on the target devices (Cisco 2950 SW )will be :
1) enable
2) configure terminal
3) rtr responder
4) exit
The query here is that :
1) Is this configuration will work ?
2) And for every Cisco 2950 Switch , i have to create seprate rtr entry on Cisco 6506 Sw for example for 50 target device i have to create 50 entries on source device 6506 ?
Thanks in advance....
Aditya
