Attempting to setup the following site.
Remote site --- C3750E --- RV325 --- VPN/Internet --- ASA --- corporate network
The RV325 is configured in router mode.
On LAN it has a 30 bit subnet configured that is connected to the C3750E.
Able to ping from remote site VLAN to RV325.
Unable to ping interface on ISPs device connected to the RV325.
Routing table appears to be correct on RV325. Shows Remote Site LANs with next hop going to C3750E and default route going to ISPs device on the WAN side.
Unable to route to Internet.
Suspect NAT issue. Have PAT configured to allow ports 80, 443, etc. But does not appear to pass traffic.
Can bring up the VPN connections between the RV325 and ASA but does not appear to pass traffic from the local LANs.
Have used a few of the RV325 units successfully at other remote locations but in gateway mode with VPNs configured with a single VLAN at the remote location.
CLI interface to RV325 has limited capability.
Are there some documents available that show the RV325 used in router mode?