Routing

Hi, I'm trying to upgrade the ISR 4331 from 3825 router and tried to run the commands below on ISR 4331 but it seems it doesn't take the commands. What commands should I use for those 2 commands on ISR 4331 in order for SNMP to be worked on ISR4331?...

Hello. I have some offices connected by gre tunnel. All of them have same config, but with new one i have a trouble - the tunnel does not work. Sorry for my bad english. run: !version 15.1service tcp-keepalives-inservice tcp-keepalives-outservice tim...

HiI have an EBGP neighbor thats gets stuck on openconfirm on one end and opensent on the other end, its running over a L2 WAN link.The neighbour is seen as directly connected, port 179 is open and I can ping accross without any MTU issues. BGP source...

version 12.4service timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname Router!boot-start-markerboot-end-marker!!aaa new-model!!aaa authentication login abc1 localaaa authorization network abc2 lo...

Does any have telnet addresses to Switches or Routers labs that I can test? Thanks ~ Jerry

Anyone have a link for EoL on the Cisco 3560 switches.    24/48 port switches, PoE (PS) or Non-Poe (TS). Cisco search and google only providing me with info on the G, E, X, and v2 models. Examples Models:      WS-C3560-48PS   or   WS-C3560-48TS     ...

Hi Experts !I'm learning about OSPF network Types. As I know, NBMA is Frame Relay or ATM, and point to multi-point is FR too. Can anyone help me distinguish the difference between those two. !Thanks ! Tuan.

Does the supervisor 8E engine fully support NBAR2? Thank you.

Hi, Pls confirm whether ASR1009-X router support IWAN functionality.  Thanks  Navneet Kumar

Hi, Please share a good doc of Riverbed WAN OPT techniques. What is it? Why we use it. Advantages CLI & GUI modes Commands Would be grateful if anyone can explain 

I have had a number of these routers show inconsistent negotiation: Either negotiate to 100FULL, or not negotiate at all "notconnect" - thus affecting WAN access I have noticed something unusual - the interfaces are seen as Gigabit even though they a...

Hi Friend, Motive: To generate looping scenario in bgp, for implementing soo community. I am trying to create loop under bgp ,CE1 & CE2 running under AS 100 , PE1/PE2 running on AS200. Topology CE1----PE1----PE2---CE2 |                               ...

Hi,    I am trying to get the following values for a cisco 3G/4G router using snmpGet or snmpWalk and MIB ciscoWan3gMIB.  The values below can be retrieved using show cellular command. I am trying to automate using snmp to report these values instead...

Does cisco 2811 support GE WICs ?  If so kindly share detail