Setting Up MPLS on HSRP Cisco Nexus Core Switches

Shawn Wice · ‎02-28-2023

Hi,

We recently setup MPLS on one interface (int eth 1/31) on CORE1 of our Dual Nexus 3500 Core Switches. From our partner site they are able to reach any device that is routing through CORE1. They cannot get to any device that is routing through CORE2.

The Network switches are running HSRP.

What is the best protocol to get our partner site to access any device connected to CORE2?

There is minimal VRF interface.

Thanks,

-Shawn

marce1000 · ‎02-28-2023

- Check this guide : https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipapp_fhrp/configuration/xe-16/fhp-xe-16-book/fhp-hsrp-mpls.html

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Shawn Wice · ‎03-06-2023

Thank you. This was helpful.

MHM Cisco World · ‎03-06-2023

hard and a lot of work need
can I know are both run vPC ?
MPLS is L2 or L3VPN ?