standby SUP module 6 card 'DISABLED' state after replacing.
acr09wlmrmn#sh redundancy
Redundant System Information :
------------------------------
Available system uptime = 1 week, 10 hours, 18 minutes
Switchovers system experienced = 0
Standby failures = 3
Last switchover reason = none
Hardware Mode = Simplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = sso
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information :
-------------------------------
Active Location = slot 5
Current Software state = ACTIVE
Uptime in current state = 1 week, 10 hours, 17 minutes
Image Version = Cisco IOS Software, c7600rsp72043_rp Software (c7600rsp72043_rp-ADVIPSERVICESK9-M), Experimental Version 12.2(20111117:121625) [maniv-es-charter 192]
This software is supported for a limited time under special agreement with Cisco Systems, Inc. Ref. case 619240497 619758305
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Wed 30-Nov-11 17:23 by maniv
BOOT = disk0:c7600rsp72043-advipservicesk9-mz-eng-sp-sre3.bin,1;disk0:c7600rsp72043-advipservicesk9-mz.122-33.SRC3.bin,1;
CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102
Peer (slot: unavailable) information is not available because it is in 'DISABLED' state