Solved: Switch Location Name

Visauk47 · ‎10-22-2019

Hi All,

I copied the config of an Old switch to configure a new switch but when I login through https:// IP into the new switch, its showing the old location, check the screenshot attached, Is there any command to add the new location of the switch.

Please let me know.

Regards,

Vis

paul driver · ‎10-22-2019

Hello

Need to change snmp-server location xx

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

View solution in original post

paul driver · ‎10-22-2019

Hello

Need to change snmp-server location xx

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Visauk47 · ‎10-23-2019

Thanks Paul, I changed the name and can see the new name on the web GUI :)

Georg Pauwen · ‎10-23-2019

Hello,

if you can access the switch with the WebGUI, can you actually open the web console ? If so, check if there is a SNMP System Summary page, and a customer-definable 'Location' text box, which lets you set the switch location...

Visauk47 · ‎10-23-2019

Hi Georg,

Issue was with the Old name mentioned on the smtp-server location config, which I have changed.

Thanks,
V