When I attempt to boot a ME1200 device I get thrown into the RedBoot prompt :
RedBoot> +M25PXX : Init device with JEDEC ID 0x20BA19.
M25PXX : Init device with JEDEC ID 0x20BA19.
Sandino ME1200 board detected (VSC7418 Rev. B).
RedBoot(tm) bootstrap and debug environment [ROMRAM]
Non-certified release, version 1_11_Cisco - built 09:17:44, Mar 7 2014
Copyright (C) 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009
Free Software Foundation, Inc.
RedBoot is free software, covered by the eCos license, derived from the
GNU General Public License. You are welcome to change it and/or distribute
copies of it under certain conditions. Under the license terms, RedBoot's
source code and full license terms must have been made available to you.
Redboot comes with ABSOLUTELY NO WARRANTY.
Platform: SANDINO (MIPS32 24KEc) SERVAL
RAM: 0x80000000-0xa0000000 [0x800224a0-0x9ffdfffc available]
FLASH: 0x40000000-0x41ffffff, 512 x 0x10000 blocks
FLASH: 0x42000000-0x43ffffff, 512 x 0x10000 blocks
== Executing boot script in 3.000 seconds - enter ^C to abort
anyone encountered this before? Typing in the below doesn't seem to help .
RedBoot> diag -p
RedBoot> fis load -d managed
No image 'managed' found
RedBoot> go
No entry point known - aborted
RedBoot> fis load -d managed.bk
No image 'managed.bk' found
RedBoot> go
No entry point known - aborted
RedBoot>
RedBoot> fis load -d managed
No image 'managed' found
RedBoot> go
No entry point known - aborted
