Switching between ap# and router#

[Andrew Duffield]

Hi

I have configured my Cisco 887VAMW with ADSL and Wifi but the only way I can configure the ap and router separately is to be connected to the router by ssh and the ap via console cable.

When at the ap# prompt, how do I get back to the router#?

I have tried the instructions on cisco.com:

Closing the Session

To close the session between the wireless device and the router’s console, perform both of the following steps.

Wireless Device

1. Control-Shift-6 x

Router

2. disconnect

3. Press Enter twice.

But it doesnt work....help!!!

Thanks

[LJ Gabrillo · Accepted solution]

When you are in router# mode in order to enter ap# mode:

cmd: #service-module wlan-ap 0 session  -of course Im sure you have convered this

from ap# to router#
PRESS: CTRL+SHIFT+6, let go, then just press X

-A line should appear on the cmd you did

-Press enter once!