02-21-2008 08:09 AM - edited 03-03-2019 08:48 PM
Trying to set up a PPP T1 in a lab from one 1760 to another 1760 using VWIC 2MFT T1 cards. This is driving me nuts, It will not let me set the timing. I would think at least one end has to have the timing set to internal. When I do the clock source or clock anything from the controller interface it says Invalid Input. ? shows no clock command. Code is 12.4(18)
Here is what I have configured so far:
controller T1 0/0
framing esf
linecode b8zs
channel-group 0 timeslots 1-24
and
interface Serial0/0:0
ip address 100.100.100.2 255.255.255.252
encapsulation ppp
Lastly, does anyone have a decent sample config for these? What I am trying to do is setup a voice lab. I have 2 1760's connecting to 2 3500 XL w/Inline power. All I want is to plug in a phone on either end and place a call. I have never worked with voice before and it's driving me nuts. Every page I seem to find on Cisco's web send me a different direction. I I could just see a config and find out what I need I could get it done.
Thank you very much
02-27-2008 12:54 PM
Use Cisco 1700 Series Modular Access Routers Configuration guide. Here you will get sufficent examples for your needs.
http://www.cisco.com/en/US/products/hw/routers/ps221/tsd_products_support_configure.html
02-27-2008 01:15 PM
Hi
02-28-2008 07:24 AM
Hi - Naren ? From FRB ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide