Routing

I have 5 Cisco 870 in my branch offices.Can I use a Cisco ASA 5505 as a VPN concentrator and the cisco 870 as a vpn client?

hellomy 5505 have got a inside ip 10.202.0.X et outise ip 25.10.10.x outside and inside ar pingable independently but a 10.202.0.4 not ping 25.10.10.X acl rules are ok) and i see nothing in loghelp ?thank you

i am stuck in a problem in whch i was given the cir i.r 80Kbps now i want to calculate the PIR can anybody help me for the solution.regardsshivlu

Dear All,Somebody can tell me what is the command on my cisco router to monitor the traffic port on WAN connection?mean that I want to see what is the ports number that go through my WAN connection.Best Regards;Boly

I hope you are fine.In fact i have an issue about a firewall installation.The firewall is behind a speedtouch adsl modem in brigded mode so the outside interface ip address is the one the isp gave me.I created a default route pointing to that outside...

Dear expertsI have one problem on Cisco 7513 router.I need to insert GEIP+ on the Cisco 7513so I insert GEIP+ to slot3 but is not work.Below log is the "show diag " output.Slot 3: Physical slot 3, ~physical slot 0xC, logical slot 3, CBus 0 Microcode ...

Greetings,I have an issue with a particular client that is running a Cisco 871 Router. It does the NAT as well as IDS functions. The problem has been happening is that Mac users cannot get upload speeds faster than about 3.0kb/s to most FTP sites. ...

Does anyone have an example config for a cisco adsl router (UK)?Check attachment for my current config. I have no idea what is wrong.Thanks in advance!

Hi,I have two router and two serial cableCisco 2620 + Smart Serial cable V.35 DTE(male)Cisco 2501 + DB60 Serial cable V.35 DTE(male)I want to connect two router by serial cableCisco 2620<-->Smart Serial Cable V.35 Male<-->V.35 Female-to-Female V.35<-...

Tell me if I understand this correctly. You use the: mac-address-table secure <mac-address> fastethernet slot/port [vlan <vlan id>] command to lock specific MACs to specific interfaces. So I take it there is no equivalent to the: switchport port-secu...

Hi,I have two router and two serial cableCisco 2620 + Smart Serial cable V.35 DTE(male)Cisco 2501 + DB60 Serial cable V.35 DTE(male)I want to connect two router by serial cableCisco 2620<-->Smart Serial Cable V.35 Male<-->V.35 Female-to-Female V.35<-...

If I do clear counters or clear counters fa0/0...it clears every stat except unknown protocol drops...(see below)...how do I clear that stat?FastEthernet0/0 is up, line protocol is up Hardware is MV96340 Ethernet, address is 001a.2f52.49f0 (bia 001a...

I have a specific requirement and cant seem to find a good solution. I'm hoping Cisco have a technology or method that I'm not familar with. Here is a quick breakdownAim - To utilise two links from a remote location to two connections at a data cente...

I have a 3560 switch which has CEF enabled on all routed interfaces. Output from show ip interfaces shows the following: IP fast switching is enabled IP CEF switching is enabled IP CEF switching turbo vector IP multicast fast switching is enable...