Tuning LACP and UDLD timers ?

[TisTos]

Hello,

Is it possible de tune the timers for (whether it's on NX-OS or IOS/XE) ?

- LACP

- UDLD

Thanks,

Mehdi

[yasirirfan · Accepted solution]

Dear Mehdi

Yes it can be done

Check this article from Cisco

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/interfaces/configuration/guide/if_cli/if_basic.html#pgfId-2266337

You can change the LACP timer rate to modify the duration of the LACP timeout. Use the lacp rate command to set the rate at which LACP control packets are sent to an LACP-supported interface. You can change the timeout rate from the default rate (30 seconds) to the fast rate (1 second). This command is supported only on LACP-enabled interfaces. To configure the LACP fast time rate, see Configuring the LACP Fast Timer Rate.

Cheers

Yasir