unable to see full output of show run command with privilege 7 in cisco 3400 series switch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2013 11:17 PM - edited 03-04-2019 09:18 PM
Hi,
After configuring user XXX with priviledge 7, User XXX is unable to see full output of show running-config but able to see show startup-config.
Not sure where is the issue.
If any one can guide me.
- Labels:
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-13-2013 09:46 AM
Hi,
This is normal behavior, a user with a custom privilege level will only see in the show run the outputs of what he is permitted to configure at his privilege level.
Regards
Alain
Don't forget to rate helpful posts.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-13-2013 10:53 AM
Questions like this come up from time to time, so it is not an uncommon issue. I agree that Alain has given exactly the correct answer - this is normal and expected behavior for privilege level 7.
HTH
Rick
Rick
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-14-2013 05:29 AM
Hi All,
Thanks for mail/reply...
I resolved this issue by applying following command.
privilege exec level 7 show running-config view full
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-14-2013 06:29 AM
Hi,
Really great info, I had never heard about this before. I think it's worth a 5
Regards
Alain
Don't forget to rate helpful posts.
