Value of ebgp-multihop ?

[sang20319951]

What is the value default  of ebgp-multihop if  admin no configure then command in the graphic ?

[Mark Malone · Accepted solution]

You use ebgp multihop so the loopbacks can form the EBGP neighbour relationship rather than the physical interface's , without the multihop statement it wont form

[sang20319951]

I see , Thank you !

[Mark Malone]

No problem this doc shows you some examples and why its also used in EBGP

http://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/13751-23.html