VRF LEAKING IN SAME SWITCH ( Cisco 6500 ).

[rpalmeida]

Hello,

I'm normally doing vrf leaking between GRT and VRF and VRF and GRT with 2 tunnels inside the same switch (6500).

I make a tunnel with GRT and another tunnel with VRF and then 2 OSPFs or ISIS with BGP and everything works perfectly.

Is there any other way to do VRF LEAKING, within the same switch?

I intend for there to be OSPF ou ISIS to redistribute routes and some routes to go from GRT to VRF and VRF to GRT.

I've done some research on the internet but I can't find anything that works...

I´m sending my 2 examples in atatchment,

Thanks.

[MHM Cisco World]

Can I see last config 

[rpalmeida]

I think the problem is that i cant ping the next-hop...

[MHM Cisco World]

The icmp is two way

You finish global into vrf 

Now 

Vrf into global 

Which need 

Export ipv4 unicast map command, I dont see it add it and check global have prefix of vrf. 

[rpalmeida]

"Export ipv4 unicast map " i dont have this command.

"Export map FROM_VRF"only.

[rpalmeida]

MHM, Should i change the context of the VRF to this:

vrf context TO_ISP
address-family ipv4 unicast
import vrf default map
export vrf default map

WIth this command i have both import/export.

[MHM Cisco World]

export ipv4 unicast map FROM_VRF

You shared config before and this command was available!! 

[rpalmeida]

You are right, it is available.

Yet wont redistribute, ;(.

MHM i must go out since it is to late for staying here.

Tomorrow at morning i will give you feedback.

Many thanks, until tomorrow.

Best Regards.

[rpalmeida]

Hello MHM,

I think the best way to redistribute GRT<->VRF is indeed creating:

1tunnel in GRT

1tunnel in VRF

And with 2 IGPs and 1BGP it is all dynamic.

Many thanks for last night you helped me trying to find a new path.

Best Regards.

[MHM Cisco World]

You are so welcome 

MHM