VRF with RP

[Johnson_Mo]

team,

is there a way to force VRF joining multiple RPs as a VRF can join only  one RP multicast at a time? 

[MHM Cisco World]

Not only vrf but also in global you can config one RP for each multicast. 

In vrf and multicast I think it hard 

Try with global and config multi rp one for each multicast. 

MHM

[Johnson_Mo]

hi boss,

if I apply it globally, it works fine but as you said in vrf, is hard that's why I a trying to find out a way to do this under vrf. 

[paul driver]

Hello
mc within a vrfs would be the same as in the global route table
As long as your unicast routing is all setup you should just enable mc routing to your vrf - Apply pim to the vrf interfaces and specify the RPs either staticky or dynamically like BSR 

[Johnson_Mo]

thanks for replying back!

applying pim to vrf int is not even a feature on my cat 9300. 

thank you  

[Johnson_Mo]

I got it resolved by the following:

ip pim vrf test rp-address 1.1.1.1 test1

ip pim vrf test rp-address 2.2.2.2 test2

now one VRF has joined to two different RPs

access-list test1

permit 239.1.1.1

access-list test2

permit 239.1.1.2