When the VSL link is brought up, then the secondary switch waits for a reload command given in the console.
how to active it without reload
Switch#show module
Switch Number: 1 Role: Virtual Switch Active
Chassis Type : WS-C4506-E
Power consumed by bacoplane : 0 Watts
Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
1 4 Sup 8L-E 10GE (SFP+), 1000BaseX (SFP) WS-X45-SUP8L-E CAT2038L3XY
2 12 10GE SFP+ WS-X4712-SFP+E CAT2047L7PK
3 48 10/100/1000BaseT Premium POE E Series WS-X4748-RJ45V+E CAT2038L1BM
M MAC addresses Hw Fw Sw Status
--+--------------------------------+---+------------+----------------+---------
1 0081.c40b.4f80 to 0081.c40b.4f83 1.0 15.1(1r)SG6 03.09.00.E Ok
2 286f.7f57.7358 to 286f.7f57.7363 2.0 Ok
3 006b.f119.9730 to 006b.f119.975f 1.2 Ok
Mod Redundancy role Operating mode Redundancy status
----+-------------------+-------------------+----------------------------------
1 Active Supervisor SSO Active
Switch Number: 2 Role: Virtual Switch Standby
Chassis Type : WS-C4506-E
Power consumed by backplane : 0 Watts
Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
1 4 Sup 8L-E 10GE (SFP+), 1000BaseX (SFP)
2 12 10GE SFP+
3 48 10/100/1000BaseT Premium POE E Series
M MAC addresses Hw Fw Sw Status
--+--------------------------------+---+------------+----------------+---------
1 0081.c40b.4dc0 to 0081.c40b.4dc3 Provision
2 286f.7fe9.5f34 to 286f.7fe9.5f3f Provision
3 00d7.8f84.3de4 to 00d7.8f84.3e13 Provision
-
Mod Redundancy role Operating mode Redundancy status
----+-------------------+-------------------+----------------------------------
1 In-Chassis Standby RPR Disabled
In show module after VSL link up secondary module stay in provision state why is this is this normal behavior of VSS
