VWIC2 on two different T1 circuits

[richreitenauer]

Hi,

I have a VWIC2 running two T1 circuits to two locations.  Can I put the controllers on the same channel group?  I also have a PPP multilink controller on a VWIC2 on channel group 0.

Such as:

controller T1 0/1/0 --- LOCATION A

cablelength long 0db

channel-group 1 timeslots 1-24

!

controller T1 0/1/1 --- LOCATION B

clock source internal

cablelength long 0db

channel-group 1 timeslots 1-24

[Reza Sharifi]

Hi,

You cannot put them in the same Etherchannel group, because the terminate in two different routers in 2 different locations.

HTH

Reza

[richreitenauer]

Thanks for the reply.  I changed it to this:

controller T1 0/1/0

cablelength long 0db

channel-group 1 timeslots 1-24

!

controller T1 0/1/1

clock source internal

cablelength long 0db

channel-group 2 timeslots 1-24