I attached a JPG of a lab setup, my question is about a virtual link would be needed if either the link would fail from Router 1 (Area 0) to Router 3 (Area 120) or Router 2 (Area 110).

Hi,We will be implementing an MPLS network at 5 locations.  I am looking at router selection and below I posted what I am looking at and current speeds and "future" speeds.Main HQ - Cisco 7201 - Proposed 45Mbps, Future "150Mbps - 200Mbps"Site 2 - Cis...

Setup:Site A Cisco 2911 -- 2 T1 WIC.  One going to Site B 1841 another going to Site C 1841.I am looking for a way to setup a Polycom QOS, judging by several forum posts about this, would it be better to create an access list with the Polycom IPs to ...

I have a Cisco 2911 with multiple sub interfaces configured.  I have the last resort route set and computers within the LAN can get out to the internet fine and can traceroute fine without a problem.  It's only when I try from the router, is when I h...

Hi,I have a VWIC2 running two T1 circuits to two locations.  Can I put the controllers on the same channel group?  I also have a PPP multilink controller on a VWIC2 on channel group 0.Such as:controller T1 0/1/0 --- LOCATION A cablelength long 0db ch...