07-01-2011 05:44 AM - edited 03-04-2019 12:52 PM
hi,
i am very new for WAN failover configuration so any one can u please tell me how to configure cisco router 1841 with two WAN link
please give me step by step
thanks in advance
Mahesh Patidar
07-01-2011 06:52 AM
Hi Mahesh,
When you are not using HSRP and two routers, you need to use "floating static routes". Here is a funny article that helps you understand them nice and easily:
http://www.routergod.com/charlesmanson/
And you can configure the default route like below...
ip route 0.0.0.0 0.0.0.0 71.23.43.123 1
or
ip route 0.0.0.0 0.0.0.0 71.23.43.123 1 track
Please rate the helpfull posts.
Regards,
Naidu.
07-01-2011 07:03 AM
Hi Mahesh
It's handy to tell more about the setup.
Do you have two equal lines or not
Which type of connections do you have? A leased line and an ADSL
...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide