I have an older 2621 router with a WIC-1ADSL card installed. When I look at the card, all three lights (CD, LP, OK) are faint. The router is running the newest 12.3(26) IOS software (c2600-i-mz.123-26.bin). When I do a show interfaces command, the ADSL WIC does not appear, only my 2 Fa ports will show up. From my understanding the WIC is supported in 12.3. Could I have a bad WIC?
Cisco DNA Center
What's new in Cisco DNA Center 2.1.2
Cisco DNA Center 2.1.2.x Features and Capabilities
Cisco DNA Center -Intent Based Networki...
A major international airport is looking to build a cutting-edge new terminal, designed to run 24/7 with no interruptions. With the airport always on round the clock, a critical component required to support this is the surveillance infrastructure, which ...
Dear expert,I am facing an issue which you may come across before. Grateful if you would teach me how to do it.I have a Cisco WS-C3650-24TS switch in MZ which I would like to configure so that on the GigabitEthernet1 / 0/1 portis configured with VLAN 100,...
Hi AllWe are looking at some new switches for our top of racks in our DC.We have looked at the 9300 series UX models with the big buffers which is classed as a high scale model.I have tried to look at some Nexus models for top of rack, but there appears t...